Description
The Tutélis 40 A type A combines the two protective devices required at the supply end of a single-phase charging circuit in a single enclosure. It arrives wired and labelled: the installer only needs to connect the incoming supply and the outgoing cable to the charging station.
It is suitable for all charging stations with built-in DC leakage current detection, such as the Ampéa 7.
Enclosure contents
- One 40 A, 30 mA, type A two-pole residual current device
- One 40 A two-pole circuit breaker, C curve, 6 kA breaking capacity
- One earth terminal block and connecting busbars
- One identification label reading “Electric vehicle charging”
- Two cable glands for cables up to 3 × 10 mm²
Technical specifications
| Characteristic | Value |
|---|---|
| Operating voltage | 230 V single-phase |
| Rated current | 40 A |
| Residual current sensitivity | 30 mA, type A |
| Breaking capacity | 6 kA |
| Enclosure | 4 modules, transparent door |
| Protection rating | IP65 |
| Compliance | NF C 15-100, IEC 61008-1 |
| Warranty | 2 years |
When to choose type B
If the charging station does not detect DC leakage currents itself, the standard requires a type B residual current device. In this case, or for a three-phase installation, choose the Tutélis Tétra type B enclosure.



